|Bule And Orange
roll forming equipment,
cold roll forming machine
5.5 kw Servo Motor Glazed Tile Roll Forming Machine High speed 4 m/min
|color coils and galvanized coil
|Width of the material
|7760 x 2000 x1500mm
|4 + 4 kw
|5.5 kw Servo Motor
The mold used in the tile press equipment requires an upper mold and six lower molds of the same size. The upper mold and the lower mold are installed first. The lower mold is directly mounted on the hexagonal wheel worktable. The upper mold is installed on the bottom surface of the slide, and place the appropriate thickness of the plate, ensure that after the upper and lower molds are closed, the gap around the four even, the distance between the upper and lower mold is equal to the thickness of the required blank. Then the above model shall prevail.
The workbench is indexed, and the rest of the five lower molds are installed. After all the upper and lower molds are installed, the car can be pressed.
|380V 50 HZ 3 Phases
|40 # oil
|Diameter 70 mm
Pressing machine equipment manual billet, billet working procedures: Before using the equipment, to check whether the connection is firm, the installation bolts, nuts are tightened, the left and right chassis should be filled with lubrication oil, in order to start the machine to start the test, the first empty Car operation carefully observe, whether there is vibration, noise, whether the oil window comes oil, whether the movement of the various parts is coordinated, all can be installed after the mold is normal, when the mold is installed, the power must be cut off, and the motor belt or large gear is manually moved to make the work, The table is transposed ,and the carriage is raised to its highest point. It is better to use an object supported between the table and the bottom surface of the slide to prevent the natural fall of the anti-skid seat and cause accidents.
Contact Person: Jing
Tel: +86 188 2511 7789 / +86 182 3376 6102